page 4
the coastal
series controls
PUMP PRIMING (Pr)
Pump priming feature begins at start-up. When spa is energized, the LCD panel will
display a “Pr” message. This mode will last approximately four to five minutes, if not
exited manually by pressing the TEMP SET pad.
UNDERWATER AND ENTRYWAY LIGHTS
The pad marked LIGHT ON/OFF turns the underwater and Entryway lights on and off.
The low-voltage system produces a night light for evening use and makes entering and
exiting the spa safer. After being on for one hour, the lights will automatically turn off.
OPTIONAL WATERCOLORS
Press LIGHT pad to turn on step one. Press LIGHT pad again to turn off for one
second. Then Press LIGHT pad again for step two. Repeat for all six options: 1-
White, 2-Violet, 3- Blue, 4-Green, 5-Red, 6-Color wash of all colors.
ZONE 1 JETS
Press ZONE 1 JETS pad for the following functions of jets in both zones: 1st press,
Pump 1 low speed; 2nd press, Pump 1 high speed; 3rd press, Pump 1 high speed/Pump
2 high speed; 4th press, Pump 1 low speed/Pump 2 high speed; 5th press, all pumps off.
SOAK TIMER AND SOAK FEATURE
Pressing the SOAK TIMER pad will turn the jet pump to low-speed and start a 59-minute
timer. The timer will display the elapsed time in one-minute increments (1-14). After 15
minutes, the display will flash the minute (15-59) for ten seconds before switching to a
steady display as a safety reminder to not overstay your soak. During the Soak Timer
mode, the temperature display can be checked by pressing the TEMP SET pad. A second
press of the SOAK TIMER pad will turn off all functions (except light) for 30 minutes, if
left uninterrupted, for an all-quiet soak. Press any pad to cancel Soak mode.
Destiny, Reward, and Euphoria Spa Models
Soak Timer: 1st press turns pump
to low-speed and starts 59-
minute timer; 2nd
press “all quiet”
mode
Heat On: Illuminates when heat is on
LCD Display:
Shows temperature,
Maintenance Reminders
Light On/Off: 1st press turns
underwater and Entryway
lights on; 2nd press
turns lights off
Temp Set: Temperature is
displayed on LCD: Press repeatedly
to increase temperature; Pause;
Repeat to decrease temperature
Zone 1 Jets:
1st press, Pump 1 low speed;
2nd press, Pump 1 high speed; 3rd press,
Pump 1 high speed/Pump 2 high speed;
4th press, Pump 1 low speed/Pump 2
high speed; 5th press, all pumps off
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales